We soldered a lead on The relay touch board（with driver）
Because it has a driver for the relay, it allows direct connection to your microcontroller board. Also, components such as crocodile clips can be connected directly. The wire is about 10 m, but the length can differ in some cases.
Just place the board on the screen and turn relay to "ON" and the board will recognize its position and convert it to touch mode. The relay driver, will turn to "ON" with just 1.6 mA consumption. Also, you can connect it to Digital output pins from Arduino etc..
Please prepare thin double sided tape or adhesive conductive sheet to stick the board. The double sided tape is not included in this product.
The images below are without the cable. The relay will activate by connecting 5 V and GND to power supply and by turning EN pin to HIGH.
Make sure the silver pad is in contact with your smartphone screen.
Specification
- Operating voltage：5 V
- With relay driver
- Relay coil resistor：139Ω
Includes
- Board with a cable x 1
Documents
- Schematic（PDF）
- Outer dimension
- Relay（Omron G6L-1F DC5）Standard/Spec
- Example of use with driver
By attaching relay touch board on shutter, and moving it in correspondence to the blink on the Arduino, you will be able to release the shutter regularly. Please see footage below.
Category
|
|
| Name | Relay Touch Board with lead（with driver） |
|---|---|
| Code | SSCI-039308 |
| SKU# | 3930 |
Related Product
-
Relay touch board with driver SSCI-024556 (2455)A board which allows you to touch your smartphone without using your hands.
-
Relay touch board（Without Driver） SSCI-024549 (2454)This is a board that allows you to touch the screen on your smartphone without using your hands. This product does NOT include driver to operate relay.
